How to make a fish w/ ribbon - origami
We are searching data for your request:
Upon completion, a link will appear to access the found materials.
Lengths are approximated (personal choice). Ribbons are curly so consider using scotch tape for 1st try.
2 strips of 15" ribbon. I used 2 colors for easier guidance. This is a standard width ribbon cut lengthwise in 1/2 each color. If you use standard width, adjust your length longer.
Fold one end 6"
Tape at fold perpendicular. Note that the red is on top of yellow.
Fold long yellow over red strip.
Fold short red over to create a "V" shape.
For clarification, I'm labeling 1-long yellow, 2-short yellow.
3-long red, 4-short red
Bring 1 (long yellow) between the reds.
Bring 1-yellow back up over 4-red. Notice 3-red.
Bring 3-red up through loop from 1-yellow. This will be referred to the "FACE", note label "F".
Flip to other side, which will be referred to the "BACK", Note label "B". Should look like this. Notice 3-red.
Bring 3-red up through yellow loop.
Pull all ends gently to form this shape.
Flip to FACE, slip 4-red under 3-red.
Bring 4-red back down over 3-red
Bring 3-red up over 4-red but under 1-yellow.
Should look like this. Notice 2-yellow.
Bring 2-yellow down over 1-yellow.
Slip 2-yellow through loop from 4-red. This completes the FACE.
Flip to the BACK. Should look like this so far. Notice 1-yellow.
Bring 1-yellow up under through red. Notice 2-yellow.
Bring 2-yellow down through loop from 1-yellow. This completes the BACK.
Pull all ends gently to form the body. Cut the ends down.
Save ends and glue in to make the tail.
Completed Fish. Enjoy!